Putting Satellite Dish On Roof

Once the satellite dish is bolted down take some roof compatible sealant and seal the edges and cover the holes you have made to make sure water doesn t get in.

Putting satellite dish on roof.

Hold it right there. One of the best ways to set up a dish is by anchoring a metal pole in the ground with concrete then mounting the dish on top of it. Many factors go into installing a satellite dish on a roof. When a solid wood beam or post is available four lag screws on the corners are usually sufficient.

Fasten the satellite dish mount to the roof using your preferred method of connectors. The next thing they do is take out the dish mount and a drill to bolt the mount to the roof and they start drilling holes into your roof. Prior to getting the new roof the customer had their dish network or directv dish installed on their roof. After the roof is installed the most common practice is re installing the dish in the same holes.

When a satellite dish is mounted to your roof it is done so using a footplate that is bolted to the roofing materials and then the dish is slid onto the mast. To properly install a mount on the roof a rafter has to be located underneath the shingles. Two in the center secured into a wall stud or roof rafter and four secured in the corners of the mount. An alternative satellite dish mounting location is at the top of a sturdy metal or wood pole.

Then holes are drilled into your roof to secure it in place. However you may wish to avoid the risk of causing roof damage with your satellite dish as poor installation or unexpected weather conditions can have a surprising impact. By adding a rubber membrane the roof is protected from the footplate rubbing and gouging it. Satellite dish installers almost automatically go for the roof to guarantee the satellite isn t obstructed.

The style and height of roof determine where the satellite dish goes on the roof. The pole gives the dish more height without it needing to be on the roof. A dish mast installed on a traditional wood framed structure should be secured with 6 lag screws. As opposed to your roof a pole offers you much more flexibility for satellite placement and can help you avoid signal loss if you choose a completely unobstructed location.