Openhab Garage Door

I tapped into the buttons on the wall and ran a pair of wires to the relayboard and connected them to common and normally open.

Openhab garage door.

This is what i did. If you have multiple garage door openers and or lights the device index is based on the order the garage door opener light s were added to the myq app. Currently have a chamberlain garage door opener and was using the myq add on to control it through openhab but they keep changing the api which renders the add on useless. I own a hörmann bisecur garage door opener without the gateway and have it connected to openhab2 the easy way.

Openhab a vendor and technology agnostic open source automation software for your home. The relay is controlled via openhab. Distance reading from the opengarage controller default in cm status switch. Relay attached to pi connected to garage wireless remote.

Door status off closed on open set invert true on channel to invert switch. My config settings. No need to wire anything in the garage. The controlling is done in one topic.

When i am leaving the highway or after i have already driven out of reach of common rf solutions it is connected via mqtt. For people with only one garage door opener the value needs to be set to 0. Setting up a garage door opener i recently installed an automatic door opener in my garage and of course i wanted to hook it up to my openhab system. Raspberry pi relay garage door remote controller and z wave door sensor and some python code.

Supported things this binding supports most of the smartthings devices that are defined in the smartthings capabilities list if you find a device that doesn t work follow these instructions to collect the required data so it can be added in a future. My first appliance is a garage door that is not only monitored contact but can also be controlled. Door sensor installed on garage door reports open close status. This tutorial assumes you have the gpio binding installed and have already gotten that working for other items.

Hi i am just making my first steps with openhab moving over from a self written interface. One press starts or stops the. This is implemented as an openhab 2 binding. A relay is connected via wire to the manual input of the garage door opener where you can also connect key remotes or manual indoor switches or whatever.

I am using a raspberry pi3b gpio pins to control a relay board which simulates someone pressing the garage door opener on the wall. A switch to open close the door 2 switches for feedback for open and closed messages. I regularly do that remotely e g. Starting openhab in debug mode will display your myq devices and the order they are listed in the api.

It has a actually 2 remote controls with one button that controls the opening. Here is my garage door hardware.